Make sure the led en on board is disrupted. Make sure the motherboard is skipped 5 V on the power input selection. Make sure the power LED is working properly instead of working backwards. Check the 5 v fuse (the 4A fuse)The chip kit sketch was improperly compressed before February 16, 2015. I guess most of you get them to work anyway, but today\'s complaint exposes the issue, which has now been resolved.
I then stick the foam around the core so that the hot and cold sides are separated by the foam. I stick the propeller to the motor now. This will be used to blow the air from the cold side. To connect the motor, I cut a slot from the foam and stuck the motor in the slot.